AVERTICALVIEW

TREX 700X Mount with  Belt Drive with NEW !!!
Vibration Dampening on mount to Heli Frame and Dampening on Camera Tray itself.   

composite G-10  Front mount will come with udated SLR gimble.
Weight 22oz  

This mount is designed for the Nitro version of the Trex 700
But it is adaptable to other large helis with a few minor changes you may have to relocated mounting gromet holes
and use a spacer or two (provided)  but should work fine.   

NOTE:   THE GIMBLE HAS BEEN UPDATED !!!   THe new SLR gimble is 7.25 inch wide over a inch bigger  for more room on the camera plate  and 2 bearings have been added to the roll axis if you decide on three axis  If you want bearings in every  axis  add 7.50 each for Abec 5 bearings it takes 6 for every point  Also improvements have been made to the servo tightner by adding sliding servo trays.  
If you want a thick camera plate for no flexing (heavy weight cameras)  add 20.00 for 1/8th thick G-10 plate.



325.00  in Kit form  two axis  pan and tilt.
Three axis add 80.00  comes with roll bearings...
plus add 20.00   for extension plates  required if you want 360 rotation  


ARM kit only  is 99.00

100.00 for Assembly.

700 mount Specs:
G-10 Black Fiber Pan and Tilt Frame, 2 disk dampening with Large Gimble (6.25 working area)
Servos HS425 360 Degree on Pan and HS 422 on tilt Belt Drive on both Axis. Weight: 22 oz    620g

Servos can be upgraded to higher specs  see the 3 axis mount page for servo upgrade prices.